System Manual
Table Of Contents
- About this Guide
- Introduction
- Web Interface
- Reference Manual
- LTE
- Network
- Network | WAN Setting (Tunnel Mode – Layer 2 GRE Only)
- Network | WAN Setting (Bridge Mode) - NOT SUPPORTED BY TELRAD
- Network | WAN Setting (Router Mode)
- Network | LAN Setting
- Network | QoS (Available in NAT, Tunnel, Router Mode)
- Network | Routing (Available in Tunnel, Router Mode)
- Network | Port Management | Port Forwarding (Available in NAT, Tunnel Mode)
- Network | Port Management | Port Trigger (Available in NAT, Tunnel Mode)
- Network | DSCP
- Network | MGMT Service | Web Service
- Firewall
- Management
- Monitoring
- About
LTE Outdoor CPE | User Manual P. 26
Step2: Enter USERNAME/PASSWORD to access the web management interface. The
default is operator / Telrad4G for operator and admin / admin for end-user.
Web management interface
Step3: After successful login, you can see “Brief Summary Page”. Brief Summary Page is
composed of many blocks and each block contains its own feature. A concise
description is presented in the block. Users can click on it to enter “Detailed
Configuration Page” to see the complete settings or tweak the configuration.
Detailed information about this page will be stated below.
Brief Summary Page
Brief Summary Page
After you’ve opened up GUI page, the first page you see is “Brief Summary Page”. This window
shows all the current settings and system information. It gives you an overview of the current
status of your device.