System Manual
Table Of Contents
- About this Guide
- Introduction
- Web Interface
- Reference Manual
- LTE
- Network
- Network | WAN Setting (Tunnel Mode – Layer 2 GRE Only)
- Network | WAN Setting (Bridge Mode) - NOT SUPPORTED BY TELRAD
- Network | WAN Setting (Router Mode)
- Network | LAN Setting
- Network | QoS (Available in NAT, Tunnel, Router Mode)
- Network | Routing (Available in Tunnel, Router Mode)
- Network | Port Management | Port Forwarding (Available in NAT, Tunnel Mode)
- Network | Port Management | Port Trigger (Available in NAT, Tunnel Mode)
- Network | DSCP
- Network | MGMT Service | Web Service
- Firewall
- Management
- Monitoring
- About
LTE Outdoor CPE | User Manual P. 36
LTE | Status | PDN
LTE > Status > PDN
■ Cid: Identity number of PDN connection.
■ APN Name: Access point name identifies specific packet data network.
■ PDN Type: The connection type of each packet data network.
■ Authentication Type: The Authentication type of each packet data network.
■ Connected: The Connection status of each packet data network.
■ IP Address: The IP address of each packet data network.
The first Cid of PDN should be considered as default. The Cid
sequence would be started from 2.