System Manual
Table Of Contents
- About this Guide
- Introduction
- Web Interface
- Reference Manual
- LTE
- Network
- Network | WAN Setting (Tunnel Mode – Layer 2 GRE Only)
- Network | WAN Setting (Bridge Mode) - NOT SUPPORTED BY TELRAD
- Network | WAN Setting (Router Mode)
- Network | LAN Setting
- Network | QoS (Available in NAT, Tunnel, Router Mode)
- Network | Routing (Available in Tunnel, Router Mode)
- Network | Port Management | Port Forwarding (Available in NAT, Tunnel Mode)
- Network | Port Management | Port Trigger (Available in NAT, Tunnel Mode)
- Network | DSCP
- Network | MGMT Service | Web Service
- Firewall
- Management
- Monitoring
- About
LTE Outdoor CPE | User Manual P. 41
LTE | Multiple PDN
LTE > Multiple PDN
Multiple PDN is a wonderful way to separate different network service. For example, users
can have Default PDN for management and multiple PDN for data transfer.
● PDN Type: Only support IPv4 right now.
●
APN Name: As titled.
●
Authentication Type: There are “None”, “PAP (Password authentication protocol)”, or
“CHAP (Challenge Handshake Authentication Protocol)” to choose from. If choosing PAP
or CHAP, users need to specify the username and password.
Cancel button
Reset fields to the last saved values.
Apply button
Commit the changes made and save to the CPE device, some
services will be reloaded.
APN name can’t be empty.
The type of the authentication is determined by the user’s service
provider.
The CPE supports at most 7 PDN connections
(Cid 2 to 8)