System Manual
Table Of Contents
- About this Guide
- Introduction
- Web Interface
- Reference Manual
- LTE
- Network
- Network | WAN Setting (Tunnel Mode – Layer 2 GRE Only)
- Network | WAN Setting (Bridge Mode) - NOT SUPPORTED BY TELRAD
- Network | WAN Setting (Router Mode)
- Network | LAN Setting
- Network | QoS (Available in NAT, Tunnel, Router Mode)
- Network | Routing (Available in Tunnel, Router Mode)
- Network | Port Management | Port Forwarding (Available in NAT, Tunnel Mode)
- Network | Port Management | Port Trigger (Available in NAT, Tunnel Mode)
- Network | DSCP
- Network | MGMT Service | Web Service
- Firewall
- Management
- Monitoring
- About
LTE Outdoor CPE | User Manual P. 43
LTE | Advanced (Not part of current release)
The below capabilities depending on eNodeB features supported and IOT, therefore these
features currently not available. For further details, please contact Telrad team.
LTE > Advanced
eMBMS is a way to deliver popular multimedia content to a mass audience. It provided an
efficient broadcasting of content only to interested receivers.
MFBI is Multi-Frequency Band Indicator. Allow CPE connect to another Band with overlap
frequency. For Example (CPE set Band 38 can connect to eNodeB with Band 41)
TM8 TDD is support dual layer beamforming
● Enable eMBMS: User can enable this service via check this box.
●
MFBI Support: User can enable this service via check this box.
●
TM8 TDD support: User can enable this service via check this box.
Cancel button
Reset fields to the last saved values.
Apply button
Commit the changes made and save to the CPE device, some
services will be reloaded.