System Manual
Table Of Contents
- About this Guide
- Introduction
- Web Interface
- Reference Manual
- LTE
- Network
- Network | WAN Setting (Tunnel Mode – Layer 2 GRE Only)
- Network | WAN Setting (Bridge Mode) - NOT SUPPORTED BY TELRAD
- Network | WAN Setting (Router Mode)
- Network | LAN Setting
- Network | QoS (Available in NAT, Tunnel, Router Mode)
- Network | Routing (Available in Tunnel, Router Mode)
- Network | Port Management | Port Forwarding (Available in NAT, Tunnel Mode)
- Network | Port Management | Port Trigger (Available in NAT, Tunnel Mode)
- Network | DSCP
- Network | MGMT Service | Web Service
- Firewall
- Management
- Monitoring
- About
LTE Outdoor CPE | User Manual P. 51
Pop-up windows to confirm reboot
●
Connection Mode: “DHCP” or “Static”.
➢ If “DHCP” mode is selected, CPE would automatically acquire configuration
information from a DHCP server.
➢ If “Static” mode is selected, users have to manually enter the required
information in below fields.
●
Host Name: currently no function.
Host Name“Telrad_2C3263”
Just an example here, in general, it will be like XXXXX_YYYYYY
(XXXXX = Service Provider)
(YYYYYY = Last six words of WAN MAC)
●
WAN MGMT and DATA Interface: Users can choose “Separate” to use different
Interface for MGMT and Data traffic, or just use “Combine” which means using same
interface for MGMT and Data. “Separate” only works in LTE mode.
Below are two simple pictures that describe this function.
NAT mode, choosing “Combine” in WAN MGMT and Data Interface