System Manual
Table Of Contents
- About this Guide
- Introduction
- Web Interface
- Reference Manual
- LTE
- Network
- Network | WAN Setting (Tunnel Mode – Layer 2 GRE Only)
- Network | WAN Setting (Bridge Mode) - NOT SUPPORTED BY TELRAD
- Network | WAN Setting (Router Mode)
- Network | LAN Setting
- Network | QoS (Available in NAT, Tunnel, Router Mode)
- Network | Routing (Available in Tunnel, Router Mode)
- Network | Port Management | Port Forwarding (Available in NAT, Tunnel Mode)
- Network | Port Management | Port Trigger (Available in NAT, Tunnel Mode)
- Network | DSCP
- Network | MGMT Service | Web Service
- Firewall
- Management
- Monitoring
- About
LTE Outdoor CPE | User Manual P. 52
NAT mode, choosing “Separate” in WAN MGMT and Data Interface
If users choose “Separate” in WAN MGMT and Data Interface, make
sure other PDN is well configured in page LTE > Multiple PDN.
●
WAN IP Address/ Subnet Mask/ Gateway Address: These values are un-editable when
the connection mode is “DHCP” and editable when the mode is “Static”. If “Combine”
is selected in “WAN MGMT and Data Interface”, data and management traffic share
the same interface. If “Separate” is selected, another WAN IP address, subnet mask
and gateway address to configure data traffic will be shown.
Two WAN IP, one for MGMT, other for DATA
●
WAN MTU: This value is “Maximum Transmission Unit”. The size of a single packet
can only be as large as MTU. If the size of the packet exceeds MTU, the packet would
be fragmented.
●
DNS1/2: Domain Name Server, editable when users select “Static” in “Connection
Mode”. Otherwise, DNS information will be given by DHCP server.