System Manual
Table Of Contents
- About this Guide
- Introduction
- Web Interface
- Reference Manual
- LTE
- Network
- Network | WAN Setting (Tunnel Mode – Layer 2 GRE Only)
- Network | WAN Setting (Bridge Mode) - NOT SUPPORTED BY TELRAD
- Network | WAN Setting (Router Mode)
- Network | LAN Setting
- Network | QoS (Available in NAT, Tunnel, Router Mode)
- Network | Routing (Available in Tunnel, Router Mode)
- Network | Port Management | Port Forwarding (Available in NAT, Tunnel Mode)
- Network | Port Management | Port Trigger (Available in NAT, Tunnel Mode)
- Network | DSCP
- Network | MGMT Service | Web Service
- Firewall
- Management
- Monitoring
- About
LTE Outdoor CPE | User Manual P. 55
Pop-up windows for reboot confirm
●
VPN Type: PPTP (with IPsec) – Not supported
L2TP (with IPsec & BCP Disable/Enable) – Not supported
GRE (Layer2/ Layer3) Tunnel Mode - Only Layer 2 supported
●
GRE Type (Layer 2)/ Destination IP Address: The IP address of the peer to build GRE
tunnel with CPE.
All information need in this page are assigned by “Tunnel Server”.
Like Server IP, Username and Password.
●
Connection Mode: “DHCP” or “Static”.
➢ If “DHCP” mode is selected, CPE would automatically acquire configuration
information from a DHCP server.
➢ If “Static” mode is selected, users have to manually enter the required
information in below fields.
●
Host Name: Currently no function.
●
WAN IP Address/ Subnet Mask/ Gateway Address: These values are un-editable when
users select “DHCP” in “Connection Mode”.
●
WAN MTU: This value is “Maximum Transmission Unit”. It is the largest size of a single
packet.
●
DNS1/2: Domain Name Server. It is editable when users select “Static” in “Connection
Mode”. Otherwise, these values will be given by DHCP server.
●
NTP1/2: It is used to calibrate the time in CPE. Users can specify two NTP servers in
“IP” or “Domain name” format.
For example 45.79.167.181 or 0.us.pool.ntp.org