System Manual
Table Of Contents
- About this Guide
- Introduction
- Web Interface
- Reference Manual
- LTE
- Network
- Network | WAN Setting (Tunnel Mode – Layer 2 GRE Only)
- Network | WAN Setting (Bridge Mode) - NOT SUPPORTED BY TELRAD
- Network | WAN Setting (Router Mode)
- Network | LAN Setting
- Network | QoS (Available in NAT, Tunnel, Router Mode)
- Network | Routing (Available in Tunnel, Router Mode)
- Network | Port Management | Port Forwarding (Available in NAT, Tunnel Mode)
- Network | Port Management | Port Trigger (Available in NAT, Tunnel Mode)
- Network | DSCP
- Network | MGMT Service | Web Service
- Firewall
- Management
- Monitoring
- About
LTE Outdoor CPE | User Manual P. 56
Cancel button
Reset fields to the last saved values.
Apply button
Commit the changes made and save to the CPE device, some
services will be reloaded.
Network | WAN Setting (Bridge Mode) - NOT SUPPORTED BY TELRAD
Network > WAN Setting
●
Operation Mode: users have NAT, Tunnel, Bridge and Router Mode to choose from.
The following pages show how to configure “Bridge mode”.
Changing the “Operation Mode” needs reboot to take effect. A pop-
up window will ask users to “Reboot” or “Continue
”. If you select
“Reboot”, CPE would reboot right away. If you select “Continue”, CPE
would not reboot automatically, you need to reboot it manually.