System Manual
Table Of Contents
- About this Guide
- Introduction
- Web Interface
- Reference Manual
- LTE
- Network
- Network | WAN Setting (Tunnel Mode – Layer 2 GRE Only)
- Network | WAN Setting (Bridge Mode) - NOT SUPPORTED BY TELRAD
- Network | WAN Setting (Router Mode)
- Network | LAN Setting
- Network | QoS (Available in NAT, Tunnel, Router Mode)
- Network | Routing (Available in Tunnel, Router Mode)
- Network | Port Management | Port Forwarding (Available in NAT, Tunnel Mode)
- Network | Port Management | Port Trigger (Available in NAT, Tunnel Mode)
- Network | DSCP
- Network | MGMT Service | Web Service
- Firewall
- Management
- Monitoring
- About
LTE Outdoor CPE | User Manual P. 57
Pop-up windows for reboot confirm
●
Connection Mode: “DHCP” or “Static”.
➢ If “DHCP” mode is selected, CPE would automatically acquire configuration
information from a DHCP server.
➢ If “Static” mode is selected, users have to manually enter the required
information in below fields.
●
Host Name: Currently no function.
Host Name“Telrad_2C3263”
Just an example here, in general, it will be like XXXXX_YYYYYY
(XXXXX = Service Provider)
(YYYYYY = Last six words of WAN MAC)
●
WAN IP Address/ Subnet Mask/ Gateway Address: These values are un-editable when
“Connection Mode” is “DHCP” and editable when “Connection Mode” is “Static”.
●
WAN MTU: This value is “Maximum Transmission Unit”. It is the largest size of a single
packet.
●
DNS1/2: Domain Name Server. It is editable when users select “Static” in “Connection
Mode”. Otherwise, these values will be given by DHCP server.
●
MultiPDN connection for Data (Only in Bridge Mode): If it is enabled, CPE will pre-
create PDN connections for local clients. Thus, a client requests an IP address from CPE,
CPE will reply an IP gotten from one of APN.
If it is disabled, only one default PDN will be established, clients need another way to
get IP address.
Below is an example for “enabled” case.