System Manual
Table Of Contents
- About this Guide
- Introduction
- Web Interface
- Reference Manual
- LTE
- Network
- Network | WAN Setting (Tunnel Mode – Layer 2 GRE Only)
- Network | WAN Setting (Bridge Mode) - NOT SUPPORTED BY TELRAD
- Network | WAN Setting (Router Mode)
- Network | LAN Setting
- Network | QoS (Available in NAT, Tunnel, Router Mode)
- Network | Routing (Available in Tunnel, Router Mode)
- Network | Port Management | Port Forwarding (Available in NAT, Tunnel Mode)
- Network | Port Management | Port Trigger (Available in NAT, Tunnel Mode)
- Network | DSCP
- Network | MGMT Service | Web Service
- Firewall
- Management
- Monitoring
- About
LTE Outdoor CPE | User Manual P. 66
About Min Rate and Max Rate, we can discuss this in 3 cases.
For example, Min Rate=50 kbps Max Rate=100 kbps
1. If 20 kbps is needed, the traffic will only get 20 kbps, CPE will not
give it 50
kbps (50 kbps=Min Rate, this can prevent wasting
bandwidth)
2. If 60 kbps is needed, the traffic at least gets 50 kbps and CPE tries
to satisfy 60 kbps requirement.
3. If 200 kbps is needed, the traffic will only get 100 kbps due to max
rate constraint.
●
Mode: Only protocol QoS
●
Protocol: “TCP”, “UDP”, “ICMP” and “ANY”. ANY includes TCP, UDP and ICMP.
●
Source/ Destination Port Range and Source/ Destination IP Range: The port and IP range
of the traffic that needs QoS.
Source/Destination Port and Source/Destination IP can be an empty
value, which means “DON’T CARE”.
Cancel button
Reset fields to the last saved values.
Apply button
Commit the changes made and save to the CPE device, some
services will be reloaded.