System Manual
Table Of Contents
- About this Guide
- Introduction
- Web Interface
- Reference Manual
- LTE
- Network
- Network | WAN Setting (Tunnel Mode – Layer 2 GRE Only)
- Network | WAN Setting (Bridge Mode) - NOT SUPPORTED BY TELRAD
- Network | WAN Setting (Router Mode)
- Network | LAN Setting
- Network | QoS (Available in NAT, Tunnel, Router Mode)
- Network | Routing (Available in Tunnel, Router Mode)
- Network | Port Management | Port Forwarding (Available in NAT, Tunnel Mode)
- Network | Port Management | Port Trigger (Available in NAT, Tunnel Mode)
- Network | DSCP
- Network | MGMT Service | Web Service
- Firewall
- Management
- Monitoring
- About
LTE Outdoor CPE | User Manual P. 73
Network | MGMT Service | Dynamic DNS
Network > MGMT Service > Dynamic DNS
Dynamic Domain Name System (DDNS) is a mechanism that can map a fixed domain name to
a dynamic IP address. This is very useful when you can only get a dynamic IP in WAN. If DDNS
is enabled, clients can connect to CPE through “DDNS Host Name”.
● Enable DDNS: Enable/Disable DDNS.
●
When DDNS is enabled, select the DDNS service provider you registered from the drop-
down list, and configure the following parameters: DDNS Service Provider, DDNS User
Name, DDNS Password, and DDNS Host Name.
Cancel button
Reset fields to the last saved values.
Apply button
Commit the changes made and save to the CPE device, some
services will be reloaded.