System Manual
Table Of Contents
- About this Guide
- Introduction
- Web Interface
- Reference Manual
- LTE
- Network
- Network | WAN Setting (Tunnel Mode – Layer 2 GRE Only)
- Network | WAN Setting (Bridge Mode) - NOT SUPPORTED BY TELRAD
- Network | WAN Setting (Router Mode)
- Network | LAN Setting
- Network | QoS (Available in NAT, Tunnel, Router Mode)
- Network | Routing (Available in Tunnel, Router Mode)
- Network | Port Management | Port Forwarding (Available in NAT, Tunnel Mode)
- Network | Port Management | Port Trigger (Available in NAT, Tunnel Mode)
- Network | DSCP
- Network | MGMT Service | Web Service
- Firewall
- Management
- Monitoring
- About
LTE Outdoor CPE | User Manual P. 79
Firewall | L3 MGMT Filter
Firewall > L3 MGMT Filter
L3 MGMT filter disallow/allows packets with certain ports and IP address which is sent to CPE.
● Click “Add +” button to add a new rule, clicking “Delete” icon ) to delete the rule.
●
Name: The name of the rule.
●
Action: Select “Permit” or “Deny” to allow the access or reject the traffic.
●
Interface: Select which interface users want to block/allow the traffic from. Available
options are “WAN”, “LAN”, or “BOTH”.
● Log: Select “Log” to have log records, or “No Log” to disable it. ( users would not see it,
log is printed in the console. )
●
Protocol: Protocol to filter. Available options are TCP, UDP, ICMP, or ANY.
●
Port: The port number to filter.
●
Src IP: The source IP to filter.
●
Dst IP: The destination IP to filter.
●
Src Mask: It would be used with Src IP to form a subnet.