System Manual
Table Of Contents
- About this Guide
- Introduction
- Web Interface
- Reference Manual
- LTE
- Network
- Network | WAN Setting (Tunnel Mode – Layer 2 GRE Only)
- Network | WAN Setting (Bridge Mode) - NOT SUPPORTED BY TELRAD
- Network | WAN Setting (Router Mode)
- Network | LAN Setting
- Network | QoS (Available in NAT, Tunnel, Router Mode)
- Network | Routing (Available in Tunnel, Router Mode)
- Network | Port Management | Port Forwarding (Available in NAT, Tunnel Mode)
- Network | Port Management | Port Trigger (Available in NAT, Tunnel Mode)
- Network | DSCP
- Network | MGMT Service | Web Service
- Firewall
- Management
- Monitoring
- About
LTE Outdoor CPE | User Manual P. 9
of FCC part 96 requirements. The Compact is Classified as a Category B CBSD which requires the following
info be recorded and uploaded as part of the CPI process per section 96.45
The CPE9000 (Category B CBSD) ) must report to a SAS to register and obtain spectrum grants per FCC part 96.
Local administration should be executed through the domain proxy and all freq, bandwidth and power
adjustments must be handled in coordination with the SAS and grant process. The device is not authorized to
transmit without a grant and ships with TX disabled. It is the responsibility of the CPI to populate the CPI database
and obtain a grant before the Device is permitted to Transmit. Location will be recorded by the professional
installer and reported to the CPI database
along with the other parameters listed in the above table
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 50cm between the radiator
and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.