System Manual
Table Of Contents
- About this Guide
- Introduction
- Web Interface
- Reference Manual
- LTE
- Network
- Network | WAN Setting (Tunnel Mode – Layer 2 GRE Only)
- Network | WAN Setting (Bridge Mode) - NOT SUPPORTED BY TELRAD
- Network | WAN Setting (Router Mode)
- Network | LAN Setting
- Network | QoS (Available in NAT, Tunnel, Router Mode)
- Network | Routing (Available in Tunnel, Router Mode)
- Network | Port Management | Port Forwarding (Available in NAT, Tunnel Mode)
- Network | Port Management | Port Trigger (Available in NAT, Tunnel Mode)
- Network | DSCP
- Network | MGMT Service | Web Service
- Firewall
- Management
- Monitoring
- About
LTE Outdoor CPE | User Manual P. 91
every the designated time. (Range: 5-60 Seconds)
● Device Name: The name of CPE. Users can log in to CPE from any device in the internal
network by entering the device name on the address bar.
➢ Current Device Name: Display the current device name.
➢ New Device Name: A field to update your current device name.
Apply button
Commit the changes made and save them to the CPE device.
Cancel button
Reset fields to the last saved values