System Manual
Table Of Contents
- About this Guide
- Introduction
- Web Interface
- Reference Manual
- LTE
- Network
- Network | WAN Setting (Tunnel Mode – Layer 2 GRE Only)
- Network | WAN Setting (Bridge Mode) - NOT SUPPORTED BY TELRAD
- Network | WAN Setting (Router Mode)
- Network | LAN Setting
- Network | QoS (Available in NAT, Tunnel, Router Mode)
- Network | Routing (Available in Tunnel, Router Mode)
- Network | Port Management | Port Forwarding (Available in NAT, Tunnel Mode)
- Network | Port Management | Port Trigger (Available in NAT, Tunnel Mode)
- Network | DSCP
- Network | MGMT Service | Web Service
- Firewall
- Management
- Monitoring
- About
LTE Outdoor CPE | User Manual P. 93
➢ Remove Last Good: Remove the last saved configuration.
➢ Reset to Last Good: Load the last saved configuration.
● Integrity Check: Integrity check for the software used in the device in case the storage
device is broken. The green check indicates the investigation is passed.
Integrity Check Window
● Rollback Settings: CPE saves two firmware with possible different versions in CPE. CPE
would choose one of them. Users can press rollback to switch to use another firmware.
A “Rollback confirming” window pops up and then starts rebooting to have change taken
effect.
Rollback confirmation window
Rebooting window