User Manual

2. 2G and 3G LED’s constant blinking every 1 sec: no SIM or bad PIN;
3. 2G/3G LED’s blinking every 1 sec: connected 2G/3G, but no data session established;
4. Blinking from 2G LED to 3G LED repeatedly: SIM holder not inserted;
5. 2G/3G LED turned on: connected 2G/3G with data session;
6. 2G/3G LED blinking rapidly: connected 2G/3G with data session and data is being transferred.
3.1.4 Hardware installation
1. Insert SIM card which was given by your ISP (Internet Service Provider). Correct SIM card orientation is shown in the
picture.
2. Attach 4G and WiFi antennas.
3. Connect the power adapter to the socket on the front panel of the device. Then plug the other end of the power
adapter into a wall outlet or power strip.
4. Connect to the device wirelessly (SSID: Teltonika_Router) or use Ethernet cable and plug it into any LAN Ethernet
port.
3.2 Logging in
After you’re complete with the setting up as described in the section above, you are ready to start logging into your
router and start configuring it. This example shows how to connect on Windows 7. On windows Vista: click Start -> Control
Panel -> Network and Sharing Center -> Manage network Connections -> (Go to step 4). On Windows XP: Click Start ->
Settings -> Network Connections -> (see step 4). You won’t see “Internet protocol version 4(TCP/IPv4)”, instead you’ll have
to select “TCP/IP Settings” and click options -> (Go to step 6)
We first must set up our network card so that it could properly communicate with the router.