Specifications

www.teltron.com
5
Telecommunications &
Electronics
X-Band Motion Sensor
FCC ID : 2AJWPTMS230IF
#202 Itplex, Gajungbuk-ro 26-41, Yusung-gu, Daejeon South Korea
TEL : [phone] FAX : [phone] email : [e-mail]
Federal Communication Commission Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
The antenna(s) must be installed such that a minimum separation distance of at least 20 cm
is maintained between the radiator (antenna) and all persons at all times.
OEM Responsibilities to comply with FCC
-The module is limited to OEM installation only.
-The OEM integrator is responsible for ensuring that the end-user has no manual
instructions to remove or install module.
-The module is limited to installation in mobile or fixed applications.
-The transmitter module must not be co-located or operating in conjunction with any other
antenna or transmitter except in accordance with FCC multi-transmitter product procedures.
-The OEM integrator will be responsible to satisfy SAR/ RF Exposure requirements, when the
module integrated into the host device.
-The OEM integrator is still responsible for testing their end-product for any additional
compliance requirements required withthis module installed (for example, digital device
emissions, PC peripheral requirements, etc.).Also, the OEM integrator is responsible to
provide to the host manufacturer for compliance with the Part 15B requirements.
-The module is a limited single-modular transmitter that complies with the § 15.212(a)
modular rules which requires the host operating condition as ;The host product should
supply the regulated power of 3.3V, 5V DC to module.The host product should comply with
part 15 requirements under conditions of excessive data rates or over-modulation.