User's Manual

TRM-300 / Integration guide
F070033PT_5.1_en
Page 24 of 26
en
- The modular transmitter has been tested in a stand-alone configuration, i.e., it hasn´t been inside
another device during testing for compliance with IC and FCC requirements.
- The modular transmitter is labeled with a permanently affixed label, with its IC and FCC
identification number.
If the identification number is not visible when the modular transmitter is installed inside another
device, then the outside of the device into which it is installed must also display a label referring
to the enclosed modular transmitter.
This exterior label must contain the following text:
“Contains FCC ID: xxxnnn
Contains IC: yyyyy-zzzzz”
Where xxxnnn is FCC ID number and yyyyy-zzzz is IC certificate number which can be found in
section 12.3 for the corresponding frequency band.
The integrator user manual must also contain clear instructions on how end users can find and/or
access the module and the IC and FCC ID.
- The modular transmitter complies with any specific rules or operating requirements that ordinarily
apply to a complete transmitter and the manufacturer provides adequate instructions along with
the device to explain any such requirements.
iii. The grantee is required to provide to other parties and end users, clear documented instructions
describing the conditions, limitations and procedures for third-parties to use and/or integrate the
modular transmitter into a host device.
iv. The grantee is responsible for full compliance.
v. Licensed grant conditions shall be listed on the grant.
vi. The modular transmitter manual must provide clear instructions explaining to the integrator the
labeling requirements and integrator user manual instructions that are required.
vii. Licensed modular transmitters must be compliant to all specific applicable licensed radio service
rules.
12.2 FREQUENCY RANGE
For Federal Communication Commission (FCC), the frequency range is:
Modulation
D288Y21NxPT
(FCC ID WT7PTRKTTRM300410)
TETRA
450-470 MHz
TI D-LMR
409-430 MHz
450-470 MHz
For Industry Canada (IC), the frequency range is:
Modulation
D288Y21NxPT
(IC 8624A-PTTRM410)
TETRA
409-430 MHz
450-470 MHz
TI D-LMR
409-430 MHz
450-470 MHz