Corporation USER MANUAL FIXED WIRELESS TERMINAL PHONECELL SX3e AMPS

PHONECELL SX3e AMPS 23 USER MANUAL
How to Set the Access Overload Class (ACCOLC)
Use the following key sequence to set the ACCOLC:
Press: #
*
2
*
< ACCOLC > #
The < > brackets represent the 2-digit ACCOLC. You must enter a
2-digit value between 00 and 15, otherwise the FWT will not update
or store this value; the existing stored parameter will remain. (For
example, to program the FWT for ACCOLC 8, enter: # * 2 * 08 #.)
How to Set the Access Method (EX) Option
Use the following key sequence to set the EX option:
Press: #
*
3
*
<EX option> #
The < > brackets represent the 1-digit EX option:
enter: 1 if the FWT must always send the full MIN (Mobile
Identification Number) when accessing the system
enter: 0 if not.
You must enter either 0 or 1, otherwise the FWT will not update or
store this value; the existing stored parameter will remain. The factory
default setting is 1.
How to Set the Roam Option
Use the following key sequence to set the Roam option:
Press: #
*
6
*
<Roam option> #
The < > brackets represent the 1-digit Roam option:
enter: 0 to enable roaming
enter: 1 to disable roaming.
You must enter either 0 or 1, otherwise the FWT will not update or
store this value; the existing stored parameter will remain. The factory
default setting is 0.
How to Set the Dial Tone After Remote On-Hook Option
Use the following key sequence to set the Dial Tone After Remote
On-Hook option:
Press: #
*
8
*
<Dial Tone option> #
The < > brackets represent the 1-digit dial tone option:
enter: 0 for no dial tone after a remote on-hook
enter: 1 to enable dial tone after remote on-hook.
You must enter either 0 or 1, otherwise the FWT will not update or
store this value; the existing stored parameter will remain. The factory
default setting is 1.
Technician Programming Commands – Continued









