Operation Manual

- 64 -
BUTTON LOCK. It is possible to lock and unlock the
setting by simultaneously pressing and holding the
“VOLT” ( g. A.21) and “MODE” ( g. A.23) buttons
for 3 seconds, and ( g. A.2) ( g. A.4) “LOK on” and
“LOK off” will appear respectively on the display.
KEYBOARD LOCK
3"
DISPLAY
KEYBOARD UNLOCK
3"
DISPLAY
TO EXIT THE “ADVANCED PROGRAMS” MENU:
press and hold the “FUNCTION” button for 3
seconds.
EXIT - ADVANCED MENU
3"
BEEEP
3.6.1 DIAGNOSTIC
Disturbance free precision adapter for supporting
the battery during the vehicle electric system
diagnostic operations (function used mainly in
workshops).
FUNCTION SELECTION
DISPLAY
Thesetvoltageispresentonthechargeclamps
when connected to the battery.
NOTE. The battery must not be disconnected
from the vehicle (so as not to lose the setup
settings) and must have a minimal voltage of
5V to guarantee the correct functioning of the
process.
ATTENTION! Check the maximum
permissible voltage on the vehicle
manufacturer’s technical specications to
preventdamagetotheon-boardelectronicsand
the battery.
Customising VOLTAGE and CURRENT
VOLTAGE
- press and hold simultaneously the “VOLT” ( g.
A.21) and “FUNCTION” buttons ( g. A.22) for 3
seconds;
- use the same buttons to select (decrease
using the “VOLT” button and increase using
the “FUNCTION” button) the desired voltage
value between 6V÷7.5V, 12V÷15V, 24V÷30V
respectively for 6V, 12V, 24V batteries; the factory
default voltage value is respectively 6.8V, 13.6V,
27.2V.
The set voltage mode will be exited automatically
after a 3” time-out.
VOLTAGE ADJUSTMENT - EXAMPLE
3"
BEEEP
DISPLAY
13.3V
13.2V
13.1V
. . . . .
. . . . .
13.7V
13.6V
13.5V
CURRENT:
- press the “MODE” button ( g. A.23) until the
desired value, set as indicated in step 6, appears
on the display ( g. A.4) and on the icon ( g. A.6).
The set current mode will be exited automatically
after a 3” time-out.
CURRENT ADJUSTMENT - EXAMPLE
3A 7A 10A 20A 30A 40A
►
3A 7A 10A 20A 30A 40A
Procedure
- press the “FUNCTION” button ( g. A.22) to select
this desired function ( g. A.13 or  g. A.12);