Operation Manual

- 65 -
- if necessary or requested by the vehicle
manufacturer speci cations, customise the
voltage and/or current values as indicated below;
- use the “VOLT” button to select the battery voltage;
- connect the clamps to the relative vehicle battery
terminals;
- the process will run automatically indicating the
voltage value on the display ( g. A.2), along with
the current ( g. A.4) after 5 seconds from the last
operation.
DISPLAY - EXAMPLE
3.6.2 SUPPLY
Constant voltage generator that can be used on
BATTERY CHANGES or on batteries with a very
low voltage (below 2V) to try to increase their
voltage to a value that is suitable for starting with a
normal charge cycle.
FUNCTION SELECTION
DISPLAY
ATTENTION! The set voltage is always
present on the charge clamps even when
disconnected from the battery.
ATTENTION! Pay particular attention to
thenominalvoltage of thebatterywhichmust
correspond to the voltage selected using the
“VOLT”buttonandindicatedonthedisplay(g.
A.1). This function DOES NOT FORESEE spark
protection on the output clamps and polarity
reversal.
Customising VOLTAGE and CURRENT
VOLTAGE
- press and hold simultaneously the “VOLT” ( g.
A.21) and “FUNCTION” buttons ( g. A.22) for 3
seconds
- use the same buttons to select (decrease
using the “VOLT” button and increase using
the “FUNCTION” button) the desired voltage
value between 6V÷7.5V, 12V÷15V, 24V÷30V
respectively for 6V, 12V, 24V batteries; the factory
default voltage value is respectively 6.8V, 13.6V,
27.2V.
The set voltage mode will be exited automatically
after a 3” time-out.
VOLTAGE ADJUSTMENT - EXAMPLE
3"
BEEEP
DISPLAY
13.3V
13.2V
13.1V
. . . . .
. . . . .
13.7V
13.6V
13.5V
CURRENT:
- press the “MODE” button until the desired value,
set as indicated in step 6, appears on the display
( g. A .4) and on the icon ( g. A.6). The set current
mode will be exited automatically after a 3” time-
out.
CURRENT ADJUSTMENT - EXAMPLE
3A 7A 10A 20A 30A 40A
►
3A 7A 10A 20A 30A 40A