VADER VOICE-ACTIVATED DIGITALLY ENHANCED RADIO PROFESSIONAL SECURE RADIO SYSTEM USER'S MANUAL ABOUT THE VADER SYSTEM The VADER communication system was developed for professional use in mobile communications within a small group that has tasks requiring high confidentiality. To secure the communication, the VADER radio features a scrambling transmission along with a high-speed frequency scanning that makes group's communication hard to be intercepted.
INSPECTION When you receive your packaged VADER system, inspect the shipping cation for any signs of damage. Then, remove and check the contents of the packing case to be certain that all items ordered have been included. Contents of the packing case may be different from those listed below if optional accessories were ordered. Standard kit Optional accessories . Radio Transceiver SR 1. Programming Cable . Antenna AT 2. Cloning Cable . Battery Clip BC 3. Headgear HG . Headgear HG .
BATTERY INSTALLATION (OR REPLACEMENT) i. Press and hold the 2 Law Levers on the side of Radio Housing at the same time aod pull down the Battery Clip to remove from the Radio Housing. 2. Release the Clamp located at both sides of Battery Cap by i using the right hand side of Latch Lever on the Radio Housing. Remarks: The left hand side of Latch Lever is wider than the right hand side, so it is not convenient to use for releasing the Clamp. 3, Pull the Battery Cap to remove from Battery Housing. 4.
FUNCTIONING METHOD OF VADER RADIO 1. The VADER radio has programmable frequencies in 1-16 Groups. Each Group from has max. 10 channels where appropriate frequencies are to be programmed. In Group #16 (in other words, position #16 at the Group Selector Switch), the Emergency signal alerting frequency is to be programmed. This frequency is also used for transmitting the Homing signal. Ba . When the radio is powered by turning the Power/Volume Switch to clockwise, an immediate scanning of each channel (max.
Emergency : Press and hold on the PTT Button. The Emergency signal (Peep! Peep!) is transmitted while the PIT Button is depressed. During the Emergency Transmit, the carrier wave is continuously transmitted and the Mic line is kept engaged, so that the voice message can also be transmitted with the Emergency signal.
OPERATION 1. Select the communication mode as appropriate for your operation, Operation Mode Function PIT Either PTT Button on the radio or Remote PTT Switch connected to the radio is being in function. VOX Built-in VOX is being in function. The transmission is automatically keyed on by your speech. Your message is sent with slight delay at 0.5 sec for avoiding clipping of the first part of speech. PIT operation via PTT Button on the radio or Remote PTT Switch remains in function.