Use and Care Manual

14B. Back wall gable install

A. Set assembled wall gable on top of back wall

B. Align gable with holes in panels

C. Use 5/16” nuts 29 and bolts 30 to loosely attach

gable to panels

D. Bump the gable tight to the panels and check

alignment (plumb)

E. Use #10 Tek screws 32 through pilot holes on outside

of gable

F. Tighten 5/16” bolts

Helpful Hint:

This step takes two step ladders and two people. Walk the gables

up and set on top of the wall panels to align. Ladders should face

each other parallel to the building.

REV. 022014