Instructions
930XC-20C • 930XC-20M • 930XC-30F • 930XC-30P
19
Tempo Communications Inc. 1390 Aspen Way • Vista, CA 92081 USA • 800-642-2155
Measurement Mode Conguration
There are two kinds of measurement mode: averaging and realtime. Under realtime mode the 930XC will undertake realtime
measurement for the connector of exterior ber and refurbish the measured trace. While under realtime mode, press Run/Stop
to stop; otherwise it will measure continuously. Under Averaging mode the tool will average the data within the measure time,
which is set by the user. When exceeding the set time, it will stop automatically and display the result. In general, averaging is
the preferred mode.
Under the parameter conguration menu use p and q to highlight “Meas. Mode.” Press Enter to select “Averaging” or
“Realtime” mode (Figure 3-14). Press to exit.
Power Meter, Laser Source, and VFL Conguration
Under the parameter conguration use p and q to highlight “PM/LS” and press Enter to enter PM/LS interface (Figure 3-15).
Refer to “Power Meter, Laser Source, and VFL Settings” in Section 4 for details.
Figure 3-13. Wavelength Conguration
Figure 3-14. Measurement Mode Conguration
Figure 3-15. Power Meter and Laser Source Conguration