Operation Manual

Manual satellite search
The manual search is usually used to fine-tune the antenna to a found satellite in
case of adverse reception conditions.
If you wish to receive signals from a new satellite that is not yet stored as a search
satellite in the control unit, the manual search function can be used to tune the
system to this satellite.
Firstly, switch your receiver to a preset station that is transmitted by the satellite
selected.
At the control device, press repeatedly until the message
„Manual search“ appears in the display.
Manual search:
Press to access.
Press or to select an option.
Press the sat button to go back one level.
Elevation „up / down“: Press to edit the option.
Azimuth „left / right“: Press to edit the option.
Tilt angle: Press or to edit the data.
Press to return.
Pan angle: Press or to edit the data.
Press to return.
LNB skew angle: Press or to edit the data.
Press to return.
SKEW „LNB Grad“: Press to edit the option.
Save „store ?“: Press to save
the settings and return to sat mode.
Programming sequence for function Manual search:
14