User's Manual

599 / Eagle Users manual Release 1.002 – September 27, 2010 20
Part #74447
Printed in USA
Fig 3-1 Eagle Ear Panel
3. Eagle Rear Panel
Figure 3-1 Eagle Rear Panel
(Bold/Underlined items are the item #
referred to in text)
GROUND TERMINAL (34)
The wing nut-equipped post is for connection
of station ground or counterpoise. See A
WORD ABOUT GROUNDING, page 3
secton 1.5. The ARRL also offers excellent
information in the ARRL Handbook
concerning station grounding.
ANT (35)
The ANT connector is an SO-239 jack used
for connection of a coaxial fed transceiver
antenna, nominal impedance 50 ohms, for use
on any band the Eagle covers.
EXT SPKR (43)
This jack is for connection of an external
speaker. When connected using a standard
1/8” phone plug, the internal speaker in Eagle
is disabled. Tip of the 1/8” phone plug is
audio, sleeve is ground. Requirements for an
external speaker connected to Eagle is
minimum 4 watts power handling, 4 ohms
minimum impedance.
KEY (36)
The rear panel on the Eagle has a 1/8” stereo
jack for connection of a key paddle. See
Figure 2.3-1 for proper wiring.
USB (37)
The rear panel on the Eagle has a Standard B
type USB connector. This connector is used
for connecting to a PC to perform updates of
the firmware, or for logging or control via
various available computer programs. Refer
to section Interfacing to a computer and
firmware updates for more information.
DC OUT (38 & 39)
The Eagle is equipped with two DC output
connectors to power various accessories. The
output power is limited to 0.5 Amp
maximum.
IN
25A
KEY
ANT
USB
ACC 1
SPKR
EXT
13.8V
FUSE
DC
MODEL 599
TEN-TEC, INC.
SEVIERVILLE, TN
MADE IN USA
WWW.TENTEC.COM
DC OUT
.5 A MAX
-
+
FCC ID DJ7-599 This device complies with
Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device
may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.