User's Manual

Wall Plate Stereo Audio Power Amplifier Built-in Bluetooth

Receiver Manual

SPECIFICATIONS

 Audio Inputs :Bluetooth Receiver or stereo audio line level

 Bluetooth Version: 3.0 EDR compliant

 Bluetooth Receive Distance:10 Meters

 Power Amplifier Type:Stereo Class-D

 Output power:15W(rms) per channel (@ RL=4 ohm)

 THD+N :0.06 % (@ RL=8 ohm, f = 1 kHz)

 Minimum Load Resistance :4 ohm

 Includes Speaker Protection circuit.

 Power Source:12 VDC/2A

Bluetooth Blue LED Status:

․Power on:0.1s on/off flash 3 times

․Pairing ok:0.5s on/off till link ok

․Link ok:0.05s on/ 0.2s off flash 2 times each 5s

․Standby:0.05s on/ 0.2s off flash 1 times each 5s

․Play music:0.1s on/ 0.1s off flash 1 times each 5s

․Link back:0.05s on/ 0.15s off flash 1 times each 5s

CONNECTIONS

1. Insert the left speaker’s + and – wires into the unit’s SPEAKER L+(left positive)

and L-(left negative)

terminals, then tighten the screws.

2. Insert the right speaker’s + and – wires into the unit’s SPEAKER R+(right

positive) and R-(right negative)

terminals, then tighten the screws.

3. Plug audio source cable with 3.5mm stereo plug in the unit’s AUX IN jack.

4. Plug power adaptor in the unit’s DC power socket with cord.

PAGE 1
Wall Plate Stereo Audio Power Amplifier Built-in Bluetooth Receiver Manual SPECIFICATIONS  Audio Inputs :Bluetooth Receiver or stereo audio line level  Bluetooth Version: 3.0 EDR compliant  Bluetooth Receive Distance:10 Meters  Power Amplifier Type:Stereo Class-D  Output power:15W(rms) per channel (@ RL=4 ohm)  THD+N :0.06 % (@ RL=8 ohm, f = 1 kHz)  Minimum Load Resistance :4 ohm  Includes Speaker Protection circuit.  Power Source:12 VDC/2A Bluetooth Blue LED Status: ․Power on:0.
PAGE 2
OPERATION 1. Select audio source between BT and AUX. 2. If switch to BT you must turn on the smart phone and enable the function of Bluetooth to work.
PAGE 3
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.