Product specifications

Wireless AC1200 ADSL2+ Dual Band Modem Router
108
In this case, you should go to Advanced Setup > WAN Service > Network Address Translation Settings to disable
NAT. Then go back here. You should be displayed with the following figure.
Operation-Passive indicates the RIP-enabled router will automatically tell other surrounding RIP-enabled routers the
newest route table and share the newest route table with them.
Operation-Active indicates the RIP-enabled router will receive and share messages sent by another RIP-enabled router
and then refresh its own route table.
Click Apply/Save to take the current settings into effect.
2.9 DNS
2.9.1 DNS Server (Static DNS)
The DNS server translates domain names to numeric IP addresses. It is used to look up site addresses based on their
names. Here you can configure the WAN DNS address:
For IPv4
 Click Advanced Setup > DNS > DNS Server, and enter the screen below. See the upper part for IPv4 setting.