User Guide
Table Of Contents
- 1 Get to Know Your Device
- 2 Quick Internet Setup
- 3 Layout
- 4 Status
- 5 Internet Settings
- 6 Wireless Settings
- 7 Bandwidth Control
- 8 MAC Address Filter
- 9 IP-MAC Binding
- 10 Port Forwarding
- 11 DDNS
- 12 DMZ Host
- 13 UPNP
- 14 Administration
- Appendix
6.5 WPS
In this part, you can configure WPS function. The WPS function enables wireless devices to quickly connect to an
encrypted WiFi network of the router. This function is disabled by default.
Enabling the WPS function via web UI
To connect a wireless device to the router using the WPS function, select the Enable, and follow the onscreen
instruction.
Enabling WPS function via WPS button
Hold on the WPS/RST button on the rear panel of the router for about 1 second and then release it to enable the
WPS function.
6.6 Wireless Parameters
In this part, you can change network mode, wireless channel, wireless bandwidth, and anti-interference settings.