User Guide
Table Of Contents
- 1 At a glance
- 2 Quick setup
- 3 Login
- 4 System status
- 5 Internet settings
- 6 Wireless
- 7 Address reservation
- 8 Bandwidth control
- 9 Authentication
- 9.1 Overview
- 9.2 Configure captive portal
- 9.3 Example of captive portal
- 9.4 User management
- 10 AP mangement
- 11 Filter management
- 12 More settings
- 12.1 LAN settings
- 12.2 WAN parameters
- 12.3 Configure static route
- 12.4 Port mirroring
- 12.5 Manage your router remotely using web UI
- 12.6 DDNS
- 12.7 Port forwarding
- 12.8 DMZ host
- 12.9 UPnP
- 12.10 Any IP
- 12.11 Security settings
- 12.12 VPN server
- 12.13 VPN client
- 12.14 IPSec
- 12.15 Example of configuring VPN conenctions
- 12.16 Multi-WAN policy
- 13 Maintenance
- Appendix
109
11.5.2 Example of configuring port filter rules
Networking requirement
An enterprise uses the router to set up a LAN to address the following requirement:
During business hours (08:00 to 18:00 on weekday),
computers with IP addresses ranging from
192.168.0.2 to 192.168.0.100 are not allowed to browse web pages. The default port number of the
web service is 80.
Solutions
The port filter function of the router can meet this requirement.
Configuration procedure
Step 1 Set up a time group.
1. Choose Filter Management > IP Group/Time Group.
2. Set a time group shown in the following figure.
Step 2 Create an IP group for clients that are disallowed to use web service, which is 192.168.0.2
to 192.168.0.100 in this example.
Step 3 Set port filter rules.
1. Choose Filter Management > Port Filter.
2. Enable this function, and click Save at the bottom of the page.
3. Click +Add. The Add window appears.
4. Set the required parameters. Configurations on the following figure are only used for