User Guide
Table Of Contents
- 1 At a glance
- 2 Quick setup
- 3 Login
- 4 System status
- 5 Internet settings
- 6 Wireless
- 7 Address reservation
- 8 Bandwidth control
- 9 Authentication
- 9.1 Overview
- 9.2 Configure captive portal
- 9.3 Example of captive portal
- 9.4 User management
- 10 AP mangement
- 11 Filter management
- 12 More settings
- 12.1 LAN settings
- 12.2 WAN parameters
- 12.3 Configure static route
- 12.4 Port mirroring
- 12.5 Manage your router remotely using web UI
- 12.6 DDNS
- 12.7 Port forwarding
- 12.8 DMZ host
- 12.9 UPnP
- 12.10 Any IP
- 12.11 Security settings
- 12.12 VPN server
- 12.13 VPN client
- 12.14 IPSec
- 12.15 Example of configuring VPN conenctions
- 12.16 Multi-WAN policy
- 13 Maintenance
- Appendix
154
VPN server 12.12
12.12.1
Overview
The router supports PPTP server and L2TP server. To enter the configuration page, choose More >
VPN Server. See the following figure.
Parameter description
Parameter
Description
VPN Server
It is used to enable or disable the PPTP/L2TP VPN server function.
Server Type
It specifies the VPN server type that the router supports, including:
- PPTP: The Point to Point Tunneling Protocol. If PPTP is selected, the peer VPN client
should be set to PPTP client.
- L2TP: Layer 2 Tunneling Protocol. If L2TP is selected, the peer VPN client should be set to
L2TP client.
WAN
It specifies the WAN port of the router for setting up a VPN connection.
Encryption
It specifies whether to enable 128-bit data encryption. This parameter only appears when
PPTP is selected.
The value of this parameter must be consistent with that of the client. Otherwise, the client
is unable to communicate with the server.
IP Address Pool
It specifies IP address range that the PPTP/L2TP clients can obtain from the VPN server to
be connected.