User Guide
Table Of Contents
- 1 At a glance
- 2 Quick setup
- 3 Login
- 4 System status
- 5 Internet settings
- 6 Wireless
- 7 Address reservation
- 8 Bandwidth control
- 9 Authentication
- 9.1 Overview
- 9.2 Configure captive portal
- 9.3 Example of captive portal
- 9.4 User management
- 10 AP mangement
- 11 Filter management
- 12 More settings
- 12.1 LAN settings
- 12.2 WAN parameters
- 12.3 Configure static route
- 12.4 Port mirroring
- 12.5 Manage your router remotely using web UI
- 12.6 DDNS
- 12.7 Port forwarding
- 12.8 DMZ host
- 12.9 UPnP
- 12.10 Any IP
- 12.11 Security settings
- 12.12 VPN server
- 12.13 VPN client
- 12.14 IPSec
- 12.15 Example of configuring VPN conenctions
- 12.16 Multi-WAN policy
- 13 Maintenance
- Appendix
158
VPN client 12.13
12.13.1
Overview
To enter the configuration page, choose More > VPN Client. By default, this function is disabled.
After you enable the function, the following page appears.
Parameter description
Parameter
Description
VPN Client
It is used to enable or disable the PPTP/L2TP VPN client function.
Client Type
It specifies the VPN client type that the router supports, including:
- PPTP: The Point to Point Tunneling Protocol. If PPTP is selected, the peer VPN server
should be set to PPTP client.
- L2TP: Layer 2 Tunneling Protocol. If L2TP is selected, the peer VPN server should be set
to L2TP client.
WAN
It specifies the WAN port of the router for setting up a VPN connection.
Server IP/Domain
Name
It specifies the IP address or domain name of the peer VPN server.