User Guide
Table Of Contents
- 1 At a glance
- 2 Quick setup
- 3 Login
- 4 System status
- 5 Internet settings
- 6 Wireless
- 7 Address reservation
- 8 Bandwidth control
- 9 Authentication
- 9.1 Overview
- 9.2 Configure captive portal
- 9.3 Example of captive portal
- 9.4 User management
- 10 AP mangement
- 11 Filter management
- 12 More settings
- 12.1 LAN settings
- 12.2 WAN parameters
- 12.3 Configure static route
- 12.4 Port mirroring
- 12.5 Manage your router remotely using web UI
- 12.6 DDNS
- 12.7 Port forwarding
- 12.8 DMZ host
- 12.9 UPnP
- 12.10 Any IP
- 12.11 Security settings
- 12.12 VPN server
- 12.13 VPN client
- 12.14 IPSec
- 12.15 Example of configuring VPN conenctions
- 12.16 Multi-WAN policy
- 13 Maintenance
- Appendix
159
Parameter
Description
User Name
It specifies the user name and password used to dial in a PPTP/L2TP VPN connection.
Password
Encryption
It specifies whether to enable 128-bit data encryption. This parameter only appears when
PPTP is selected.
The value of this parameter must be consistent with that of the client. Otherwise, the client
is unable to communicate with the server.
VPN Proxy
With this function enabled, clients access the internet through the peer router that has
established a VPN server.
Remote LAN
It specifies the network segment of the LAN of the PPTP/L2TP server.
Remote Subnet
Mask
It specifies the subnet mask of the LAN of the PPTP/L2TP server.
Status
It specifies whether or the corresponding rule is enabled.
12.13.2 Configure the router as a PPTP/L2TP VPN client
Step 1 Choose More > VPN Client, and enable the function. The following configuration page
appears:
Step 2 Set required parameters.
Client Type, WAN, and Encryption should be identical with its peer VPN server. -
Click on the upper-right corner on the page to get the detailed explanation to the parameters -
here.
Step 3 Click Save to apply your settings.
---- End