User Guide
Table Of Contents
- 1 At a glance
- 2 Quick setup
- 3 Login
- 4 System status
- 5 Internet settings
- 6 Wireless
- 7 Address reservation
- 8 Bandwidth control
- 9 Authentication
- 9.1 Overview
- 9.2 Configure captive portal
- 9.3 Example of captive portal
- 9.4 User management
- 10 AP mangement
- 11 Filter management
- 12 More settings
- 12.1 LAN settings
- 12.2 WAN parameters
- 12.3 Configure static route
- 12.4 Port mirroring
- 12.5 Manage your router remotely using web UI
- 12.6 DDNS
- 12.7 Port forwarding
- 12.8 DMZ host
- 12.9 UPnP
- 12.10 Any IP
- 12.11 Security settings
- 12.12 VPN server
- 12.13 VPN client
- 12.14 IPSec
- 12.15 Example of configuring VPN conenctions
- 12.16 Multi-WAN policy
- 13 Maintenance
- Appendix
177
To configure advanced settings, click Advanced. And use the same configurations to set the peer
device.
Step 2 Configure Router_Branch.
1. Log in to the web UI of the router Router_Branch.
2. Choose More > IPsec, and click +Add. The Add configuration page appears.
3. Set required parameters.
(1) Select the WAN port enabled with IPSec, which is WAN1 in this example.
(2) Keep Encapsulation Mode, Connection Name, Tunnel Protocol, Key Negotiation, and
Pre-shared Key identical with its peer Router_HQ.
(3) Remote Gateway: Enter the WAN IP address of its peer Router_HQ, which is
202.105.11.22 in this example.
(4) Local LAN/Prefix Length: Enter the LAN network segment/subnet mask of
Router_Branch in the defined format, which is 192.168.0.0/24 in this example.
(5) Remote LAN/Prefix Length: Enter the LAN network segment/subnet mask of
Router_HQ in the defined format, which is 192.168.1.0/24 in this example.
4. Click Save.
---- End