User Guide
Table Of Contents
- 1 At a glance
- 2 Quick setup
- 3 Login
- 4 System status
- 5 Internet settings
- 6 Wireless
- 7 Address reservation
- 8 Bandwidth control
- 9 Authentication
- 9.1 Overview
- 9.2 Configure captive portal
- 9.3 Example of captive portal
- 9.4 User management
- 10 AP mangement
- 11 Filter management
- 12 More settings
- 12.1 LAN settings
- 12.2 WAN parameters
- 12.3 Configure static route
- 12.4 Port mirroring
- 12.5 Manage your router remotely using web UI
- 12.6 DDNS
- 12.7 Port forwarding
- 12.8 DMZ host
- 12.9 UPnP
- 12.10 Any IP
- 12.11 Security settings
- 12.12 VPN server
- 12.13 VPN client
- 12.14 IPSec
- 12.15 Example of configuring VPN conenctions
- 12.16 Multi-WAN policy
- 13 Maintenance
- Appendix
180
Pre-shared Key: 87654321
Step 1 Configure IPSec connection.
1. Choose More > IPsec, and click +Add. The Add configuration page appears.
2. Set required parameters.
Configurations on the following figure are only used for examples.
(1) Set IPSec to Enable.
(2) Set Encapsulation Mode to Transport.
(3) Set WAN to the WAN port bound to the IPSec tunnel, which is WAN1 in this example.
(4) Set Connection Name to the name of the IPSec tunnel, which is HQ in this example.
(5) Set Pre-shared Key to 87654321.
(6) Click OK.
Step 2 Configure L2TP server.
1. Choose VPN > VPN Server.
2. Set required parameters.
(1) Set VPN Server to Enable.
(2) Set Client Type to L2TP.
(3) Set WAN to the WAN port bound to the IPSec tunnel, which is WAN1 in this example.
(4) Set IPSec Encryption to HQ.
3. Click Save.
Step 3 Add L2TP users.
1. Choose VPN > PPTP/L2TP Server, locate PPTP/L2TP User module.