User Guide
Table Of Contents
- 1 At a glance
- 2 Quick setup
- 3 Login
- 4 System status
- 5 Internet settings
- 6 Wireless
- 7 Address reservation
- 8 Bandwidth control
- 9 Authentication
- 9.1 Overview
- 9.2 Configure captive portal
- 9.3 Example of captive portal
- 9.4 User management
- 10 AP mangement
- 11 Filter management
- 12 More settings
- 12.1 LAN settings
- 12.2 WAN parameters
- 12.3 Configure static route
- 12.4 Port mirroring
- 12.5 Manage your router remotely using web UI
- 12.6 DDNS
- 12.7 Port forwarding
- 12.8 DMZ host
- 12.9 UPnP
- 12.10 Any IP
- 12.11 Security settings
- 12.12 VPN server
- 12.13 VPN client
- 12.14 IPSec
- 12.15 Example of configuring VPN conenctions
- 12.16 Multi-WAN policy
- 13 Maintenance
- Appendix
32
Parameter
Description
this wireless network.
- Only Allow: Only wireless clients with the specified MAC address can
connect to this wireless network.
- Only Forbid: Only wireless clients with the specified MAC address cannot
connect to this wireless network.
MAC Filters
List
MAC Filters List
It specifies the wireless access control list you configured.
MAC Address
It specifies the MAC address of the client to which the rule applies.
Remark
(Optional) It specifies the brief description you set for the corresponding
MAC address.
Effective
Network
It specifies the wireless network(s) to which the wireless client with this
MAC address applies.
Status
It specifies whether or not the rule is enabled.
6.3.2 Configure a MAC filter rule
- A maximum of 64 rules is allowed for each SSID, and 100 rules for each frequency band.
- The MAC filter rule will be invalidated if the SSID it maps has been changed. You are required to
manually choose an enabled wireless network to apply the MAC filter rule.
Step 1 Enable MAC Filters, and click Save at the bottom on the page.
Step 2 Configure MAC address filter mode for each SSID by selecting from the MAC Address Filter
drop-down list menu.
Step 3 Add rule(s).