User Guide
Table Of Contents
- 1 At a glance
- 2 Quick setup
- 3 Login
- 4 System status
- 5 Internet settings
- 6 Wireless
- 7 Address reservation
- 8 Bandwidth control
- 9 Authentication
- 9.1 Overview
- 9.2 Configure captive portal
- 9.3 Example of captive portal
- 9.4 User management
- 10 AP mangement
- 11 Filter management
- 12 More settings
- 12.1 LAN settings
- 12.2 WAN parameters
- 12.3 Configure static route
- 12.4 Port mirroring
- 12.5 Manage your router remotely using web UI
- 12.6 DDNS
- 12.7 Port forwarding
- 12.8 DMZ host
- 12.9 UPnP
- 12.10 Any IP
- 12.11 Security settings
- 12.12 VPN server
- 12.13 VPN client
- 12.14 IPSec
- 12.15 Example of configuring VPN conenctions
- 12.16 Multi-WAN policy
- 13 Maintenance
- Appendix
64
1. Enter the Email Address and Email Password of the email account used to send
authentication emails.
2. Enter the SMTP Server and SMTP Server Port of the email account, select SSL.
3. Enter another email address in Account for Test box,and click Test. The configurations are
correct when you receive a notification as follows:
- If you failed to send test email, please check the SMTP Server of the email account for sending
test email.
- The default SMTP Server Port is 25. If you select SSL, the server port will change. Please contact
your email service provider for the information.
Step 3 Configure authentication page settings.
1. Set required parameters for the authentication page by following the on-screen
instructions. Configurations on the following figure are only used for examples.
2. Click Save at the bottom on the page.
---- End