User's Manual

10 / 12
6.3.3 Find Target Installation Position:
1) Paste 2~3mm thickness Silicone Gel on top of the probe.
2) Put the probe to the target zone of tank bottom in step 6.3.2 and
check the real time Mobile APP reading, and make sure these
conditions below are approved to confirm the installation position:
A. Real Time & Smooth Value are similar
B. Signal Strength more than 60 or stable
C. Valid Signal Quantity is stable
D. Tilt Angle is less than 11 Degrees
3) Mark the position to be target installation position after approve the
Mobile APP data show