User's Manual

11 / 12
6.3.4 Fix the probe to the bottom of tank
1) Remove the probe in step 6.3.3, and clean the installation zone again
to be AS DRY AS POSSIBLE.
2) Put the probe inside the Bracket Holder and use Back Support to fix
the probe(Aim at the Bayonet)
3) Stick the Silicone Ring exactly on top of the probe. Inject the Silicone
Gel inside the ring and Overflow a little bit to make sure it’s full
4) Stick the Bracket Holder on the target installation position and use Twon
Stainless Steel Strap to fix the Bracket & Probe
5) Verify the installation
After fixing the screw, use Mobile APP to check again the data to be
sure the same or similar in step 6.3.3 to complete the installation.