Operator Manual

SAFETY PRECAUTIONS
3
3640 330580 (2--08)
SAFETY PRECAUTIONS
The following symbols are used throughout this
manual as indicated in their description:
W ARNING: To warn of hazards or
unsafe practices that could result in
severe personal injury or death.
FOR SAFETY: To identify actions that
must be followed for safe operation of
equipment.
The machine is suited to sweep disposable
debris. Do not use the machine other than
described in this Operator Manual. The machine
is not designed for use on public roads.
The following information signals potentially
dangerous conditions to the operator or
equipment:
W ARNING: Heavy hopper. Get help to
handle.
W ARNING: Brush throws debris. Stop
motor before lifting hopper.
W ARNING: Moving belt and fan. Keep
away.
W ARNING: Engine emits toxic gases.
Severe respiratory damage or
asphyxiation can result. Provide
adequate ventilation. Consult with your
regulatory agency for exposure limits.
Keep engine properly tuned.
FOR SAFETY:
1. Do not operate machine:
-- Unless trained and authorized.
-- Unless operation manual is read and
understood.
-- In flammable or explosive areas unless
designed for use in those areas.
2. Before starting machine:
-- Check for fuel leaks.
-- Keep sparks and open flame away
from refueling area.
-- Make sure all safety devices are in
place and operate properly.
3. When using machine:
-- Do not pick up burning or smoking
debris, such as cigarettes, matches or
hot ashes
-- Go slowly on inclines and slippery
surfaces.
-- Use care when reversing machine.
-- Do not carry riders on machine.
-- Always follow safety and traffic rules.
-- Report machine damage or faulty
operation immediately.
4. Before leaving or servicing machine:
-- Stop on level surface.
-- Move directional lever into Park
position.
-- Turn off machine and remove key.
5. When servicing machine:
-- Avoid moving parts. Do not wear loose
jackets, shirts, or sleeves when
working on machine.
-- Use hoist or jack that will support the
weight of the machine.
-- W ear eye and ear protection if using
pressurized air or water.
-- Disconnect battery connections before
working on machine.
-- Keep flames and sparks away from
fuel system service area. Keep area
well ventilated.
-- Avoid contact with battery acid.
-- Use Tennant supplied or equivalent
replacement parts.
6. When loading/unloading machine
onto/off truck or trailer:
-- Turn off machine.
-- Use truck or trailer that will support
the weight of the machine.
-- Use winch. Do not push the machine
onto/off the truck or trailer unless the
load height is 380 mm (15 in) or less
from the ground.
-- Block machine tires.
-- T ie machine down to truck or trailer.