Replace detergent pump

IB 340726 (09-2004)2
16. Use t wo hex screws (5) and two hex nuts (6) to
install the detergent pump plate (2) onto the
detergent box bracket (A).
17. Attach the loose end of the 21” hose (11) to the
valve coupling (B). If necessary, trim hose to
size before attaching it to the valve coupling.
18. Attach the loose end of the 15” hose (11) to the
appropriate fitting (D) on the FaST foam filter
group. If necessary, trim hose to size before
attaching it to the fitting.
19. T ighten the hose clamp (10) over the end of the
15” hose (11) and the fitting (D) on the FaST
foam filter group.
20. Attach the detergent pump (1) cable to the same
connector the cable from the old pump was
connected.
21. If necessary, tighten the detergent box bracket
(A) onto the machine.
22. Reinstall the FaST PAK (E) into the detergent
box bracket (A).
23. Reinstall the front cover onto the machine.
24. Unlock and close the solution tank cover.
25. Fill the solution tank approximately 1/2 full of
cool clean water.
26. Unlock and close the solution tank cover.
27. T urn on the FaST system and propel the
machine forward.
28. Scrub a small section of floor to ensure machine
is functioning properly. It may take several
minutes for the FaST system to reach
maximum foaming.