Operator Manual

OPERATION EN
7
EX- SC- 1020 (04- 10)
2. Attach desired accessory tool to hoses.
3. T urn on Vacuum/Pump switch.
4. Operate accessory tools as normal (Figure 8).
NOTE: When cleaning upholstery, always check
cleaning instructions sewn in furniture by manufacturer.
FIG. 8
5. After cleaning, relieve water pressure from tool
before disconnecting hose. Squeeze trigger for five
seconds after turning off switch.
DRAINING TANKS
FOR SAFETY: When servicing machine, unplug
cord from wall outlet.
ATTENTION: Use different buckets to fill and drain
machine to prevent solution system clogs.
DRAINING RECOVERY T ANK
1. T urn off machine and unplug power cord.
2. T urn drain hose knob counterclockwise and pull out
plug to drain (Figure 9).
FIG. 9
3. After draining, replace drain hose knob securely.
DRAINING LEFTOVER CLEANING SOLUTION
1. Disconnect vacuum hose from inlet tube and
replace with 1.4m (4 1/2 ft) clean- out hose,
supplied with machine (Figure 10).
FIG. 10
2. T urn on Vacuum/Pump switch.
3. Remove solution tank lid and vacuum out leftover
solution.
4. Drain recovery tank.
MACHINE MAINTENANCE
To keep machine in good working condition, simply
follow machines daily, weekly and monthly
maintenance procedures.
FOR SAFETY: When servicing machine, unplug
cord from wall outlet.
DAILY MAINTENANCE
(Every 4 Hours of Operation)
1. Drain and rinse out recovery tank thoroughly
(Figure 11).
FIG. 11