Operator Manual

MAINTENANCE
108
T17 9020160 (05−2014)
REPLACING THE SWEEPING SIDE
BRUSH(ES)
Replace the brushes when they no longer clean
effectively.
1. Raise the side brush assembly and turn off
the machine.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, set parking brake, and remove key.
2. Reach into the center of the brush and
remove the cotter pin holding the brush and
the retaining washer to the hub.
3. Remove the side brush and retaining washer
from under the side brush assembly.
4. Place the new side brush underneath the side
brush and align the channel in the side brush
receptacle with the two brush locks on the
side brush hub.
5. Lift the side brush up onto the side brush hub,
hold the side brush onto the hub, install the
retaining washer onto the hub, and reinstall
the cotter pin into the hub.