Operator Manual

MAINTENANCE
110
T17 9020160 (3−2019)
REPLACING THE PRE−SWEEP CYLINDRICAL
BRUSH
Rotate the brushes from front-to-rear after every
50 hours of operation.
Replace the brush when it no longer cleans
effectively.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, set parking brake, and remove key.
1. Turn off the machine.
2. Loosen both Pre−Sweep cover latches.
3. Lift the Pre−Sweep cover, lock the cover
open, and engage the Pre−Sweep cover
support.
4. Loosen and remove the left brush arm knob.
5. Remove the left brush arm.
6. Remove the three knobs holding the
Pre−Sweep side skirt and side skirt plate to
the Pre−Sweep assembly.