Operator Manual

MAINTENANCE
116
T17 9020160 (5−2014)
LEVELING THE REAR SQUEEGEE
Leveling the squeegee ensures the entire length
of the squeegee blade is in even contact with the
surface being scrubbed. Perform this adjustment
on an even and level floor.
1. Lower the squeegee and drive the machine
several meters (feet) forward and slowly bring
the machine to a stop.
2. Check the squeegee deflection over the full
length of the squeegee blade.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, set parking brake, and remove key.
3. Lower the Rear bumper door / step.
4. If the deflection is not the same over the full
length of the blade, use the tilt adjust knob to
make adjustments.
DO NOT disconnect the vacuum hose from
the squeegee frame when leveling squeegee.
5. To adjust the squeegee leveling, loosen the tilt
lock knob.
6. Turn the squeegee tilt adjust knob
counter-clockwise to decrease the deflection
at the ends of the squeegee blade.
Turn the squeegee tilt adjust knob clockwise
to increase the deflection at the ends of the
squeegee blade.
7. Tighten the tilt lock knob.
8. Drive the machine forward with the squeegee
down to recheck the squeegee blade
deflection if adjustments were made.
9. Readjust the squeegee blade deflection if
necessary.
10. Raise the Rear bumper door / step when
finished leveling the rear squeegee.