Operator Manual

MAINTENANCE
123
T17 9020160 (5−2014)
BELTS
CYLINDRICAL BRUSH DRIVE BELTS
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, set parking brake, and remove key.
The brush drive belts are located on the
cylindrical brush scrub head. Check the belts for
damage and wear after every 200 hours of
operation.
PRE−SWEEP BRUSH DRIVE BELT (OPTION)
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, set parking brake, and remove key.
The Pre−Sweep brush drive belt is located inside
the Pre−Sweep assembly on the right side of the
cylindrical brush. Check the belt for damage and
wear after every 200 hours of operation.
BRAKES
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, set parking brake, and remove key.
The foot brake and the parking brake operate the
linkage that controls the brakes on the rear
wheels.
The foot pedal should not travel more than 25 mm
(1in) to engage the brake. Check the brake
adjustment after every 200 hours of operation.
TIRES
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, set parking brake, and remove key.
The machine has three solid rubber tires: one in
front, and two in the rear of the machine. Check
tires for damage and wear after every 500 hours
of operation.