Operator Manual

MAINTENANCE
124
T17 9020160 (12−2019)
PUSHING, TOWING, AND TRANSPORTING
THE MACHINE
PUSHING OR TOWING THE MACHINE
FOR SAFETY: When servicing the machine,
do not push or tow the machine without an
operator in the seat controlling the machine.
If the machine becomes disabled, it can be
pushed from the front or rear, but it can only be
towed from the front.
Only push or tow the machine for a very short
distance and do not exceed 3.2 kp/h (2 mph). It is
NOT intended to be pushed or towed for a long
distance or at a high speed.
ATTENTION! Do not push or tow machine for
a long distance or damage may occur to the
propelling system.
TRANSPORTING THE MACHINE
FOR SAFETY: When transporting Lithium− ion
Battery Model, contact Tennant or your local
regulatory authorities for proper transporting
instructions.
1. Raise the squeegee, scrub head, and
brushes.
FOR SAFETY: When loading/unloading
machine onto/off truck or trailer, drain tanks
before loading machine.
2. Park the trailer on a level surface and apply
parking brake.
3. Position the machine at the loading edge of
the truck or trailer.
FOR SAFETY: When loading/unloading
machine onto/off truck of trailer, use ramp,
truck or trailer that will support the weight of
the machine and operator.
FOR SAFETY: When loading/unloading
machine onto/off truck of trailer, do not
load/unload on ramp inclines that exceed 21%
/ 12º grade
NOTE: The machine ability to climb a ramp is
affected by tire wear, ramp surface, weather
conditions, and other factors. Trailering should be
performed by personnel trained on how to safely
load a machine.
4. Drive the machine ontop the trailer or truck.
Position the machine so the weight of the
machine is safely distributed and can be
safely strapped down to the trailer or truck.
FOR SAFETY: When loading/unloading
machine onto/off truck of trailer, stop on a
level surface, set parking brake and leave the
key in the ON position until all tie−down
straps are secure.
NOTE: The drive wheel dynamic brake system is
active when the key is in the ON position.
5. Lower the scrub head and rear squeegee.