Operator Manual

SUPERVISOR CONTROLS
146
T17 9020160 (3−2019)
CHANGING THE BATTERY TYPE
Changing the battery type allows the machine to
be programmed for the correct battery type if the
battery has been changed.
IMPORTANT: Before charging, make sure that
the charger setting is properly set for the
battery type.
NOTE: Use a charger with the proper rating for
the battery to prevent damage to the battery or
reduce the battery life.
1. Turn on the machine, login to the main
operation screen, and press the setting button
to access the supervisor settings screen. See
ENTERING THE SUPERVISOR MODE.
2. Press the Battery Type button to access the
battery selection screen.
3. Press the button for the applicable battery
from the list. If necessary, use the up arrow
button and the down arrow button to navigate
through the list of batteries.
4. If a battery sub list appears on the screen,
press the button for the applicable battery
from the list.
5. If Are You Sure appears on the screen, press
either the yes button or the no button.
NOTE: If yes button is pushed the supervisor
settings screen will reappear in the display. If the
no button is pushed the applicable battery sub list
will reappear in the display.
CALIBRATING THE TOUCH
1. Turn on the machine, login to the main
operation screen, and press the setting button
to access the supervisor settings screen. See
ENTERING THE SUPERVISOR MODE
2. Press the Calibrate Touch button to
recalibrate touch if the touch points become
misaligned.