Operator Manual

SUPERVISOR CONTROLS
150
T17 9020160 (3−2019)
CHANGING THE REAR VIEW CAMERA
SETTINGS
Changing the rear view camera settings allows
the time the rear view camera remains on when
the rear view camera button is pushed to be
changed. The rear view camera can be set to any
time between 5 seconds and 15 seconds.
1. Turn on the machine, login to the main
operation screen, and press the setting button
to access the supervisor settings screen. See
ENTERING THE SUPERVISOR MODE.
2. Press the Camera Settings button to access
the rear view camera settings screen.
Press the increase button to increase the
time the rear view camera remains on
when the operator presses the rearview
camera button.
Press the decrease button to decrease the
time the rear view camera remains on
when the operator presses the rearview
camera button.
Press the home button to navigate back to
the main operating screen.
Press the back button to navigate back to
the previous screen.
PROGRAMMING THE ZONE CONTROL
BUTTONS
Programming the zone control buttons allows the
parameters for the zone control buttons to be
changed / updated to meet scrubbing / sweeping
demands.
1. Turn on the machine, log into the supervisor
screen, and press the setting button to access
the supervisor settings screen. See
ENTERING THE SUPERVISOR MODE
2. Use the brush pressure increase (+) button
and the brush pressure decrease (−) button to
set the zone brush pressure.
3. Use the solution increase (+) button and the
solution decrease (−) button to set the zone
solution flow level.