Operator Manual

OPERATION
23
T17 9020160 (NIL)
SOLUTION TANK INDICATOR
The solution tank indicator displays the amount of
liquid in the solution tank. Refill the solution tank
when there are no longer any bars shown in the
display. The machine will stop scrubbing when the
solution tank is empty.
CONTRAST CONTROL BUTTON
Use the Contrast control button to darken / lighten
the LCD display.
CONFIGURATION MODE BUTTON
The Configuration mode button is for accessing
the configuration and diagnostic modes. Only
properly trained service personnel and TENNANT
representatives should access these modes.
1-STEP BUTTON
Press the 1−STEP button to activate all selected
sweeping and scrubbing functions. Prior to the
1−STEP button being pushed, the lights above all
the selected sweeping / scrubbing functions will
be on but the selected functions will be in the
standby mode until the 1−STEP button is
pressed. Press the 1−STEP button again when
finished cleaning to stop all scrubbing and
sweeping functions.
NOTE: The squeegee will remain down and the
vacuum fan will remain on for a few seconds to
pick up remaining water after the 1−STEP button
is deactivated.
The indicator light above the button will illuminate
when the 1−STEP button is activated.